BRIAN LIFE AND TECH

Hi all, for the past 14 months, I have been travel long distance around 160+km go to office and back.  Every month, average distance around 3000km and I am using my CT100 for that travel,most of the time. It is quite safe travel, although with many heavy vehicle using the same road with me. However, it become concern to me lately about my safety as I mostly left my office quite late. sometimes, its night already. so, I need to make sure that vehicle on the back can notice/see me and know what is my next move during my travel. Therefore, I decide to install extra rear light which is third brake light, turn signal and also tail light at the most visible position (decided to install on the rear storage GIVI box). Figure 1: brake light and turn signal light test Purchased the LED light as below which had all the function. Tail light, brake light and turn signal. Figure 2: LED 48 brake, tail and turn signal. Then, wiring installation are required. Refer ...

Below shown electrical wiring diagram for my modenas CT100. This will help anyone who have problem with electrical system for this model. Modenas CT100 electrical wiring diagram Looking at the electrical diagram, it is quite simple and you need only multimeter to do some troubleshooting if there is problem with wiring connection. Thank you

hi, this is our classic Brother electric sewing machine. it is very old. But, still works fine. Model is similar to 681B-UG brother sewing machine model 681B-UG Unfortunately, for the past few weeks, there are little problem with the foot pedal which caused slight leakage current when operate the machine. was not sure where the problem coming from. but, I try to investigate using my little knowledge about this kind of thing. At first, I am looking at the basic things like connection inside the main plug, cable that connect from main plug to the machine, whether any damage have been occur or not to its insulation/disconnect etc. However, nothing have been found So, I start to disconnect the cable that connect to the motor and light via white connector to identify the problem..what I found is one of the ground cable are damaged. This caused disconnect between Earth cable from main plug and the machine body. Foot pedal ydk yc-180 after realised that issue and fix...