BRIAN LIFE AND TECH

Hi, i found that, many people having trouble trying to assemble back the kenwood km280 top cover after disassembled it.  refer to link below: kenwood mixer problem Two main problem as shown below, please look below; 1) unable to fit the cover in place due to something stuck inside..if you push harder, then, you might broke something. the only way to fit the cover back is by removing the knob before fitting the cover. Please refer to figure below. after removing the dial knob, you need to sit the dial circuit properly on it holder, then you can fit the cover properly. Figure 1: remove the dial knob before fitting the mixer cover 2) usually, when you diassemble the cover, some connection might not sit properly and are not in its place and sometime you dont know where that cable connector goes. figure below show common connector misplace: Figure 2: above show common misplace connector Figure 3: it sit under the mixer motor as shown in fgure Hope this note hel...

this iron has been broken since 2013 and been in the storage since. last week, when I am cleaning and clearing the house, I found this iron, and instead of throwing it out, I try to play around it to see whats inside and if it possible to fix it or not. image of iron model ST50 checking the main plug show good continuity and the fuse in the plug also working. BOTTOM OF ST50 IRON tracing the cable into the iron after remove the top cover, it show the present of the voltage when check by voltmeter. removed to cover showing internal of iron From that point..I measure the voltage reading at the rheostat (to control the heating level) and it shows no voltage. meaning there is some problem in between. thermal cutoff fuse image detail measurement of continuity shows that the thermal fuse got broken. at normal condition (room temperature), even without supply, the fuse should show connection on both end. but the one in the picture show open circuit meaning that the...

Hi, Peace upon you all. This afternoon, my wife's food processor Kenwood km280 suddenly dead..she planned to prepare Dorayaki for us all, to eat in the evening. Fig 1: Kenwood KM280 mixer/food processor Unfortunately, after pours mix all the ingredient into the bowl, switch On the main plug and adjust switch knob to no 1 speed, nothing happens. After many tried, after referring to the manual that comes with this food processor (KM280), she gives up and asks me to do something about it. The first step to troubleshoot the problem is to check the power from the main plug and also the fuse. The outcomes are all well and working fine. Second, check the internal connection and gearing, visually. the reason is to make sure no visible damage to the cable and gearing. This will require disassembly of the top cover. It can be done by removing six screws under. after top cover is removed, internal circuits, motor, and gears (figure below) can be observed for any damage. Fortunate...